Injector Tube Adapter Replacement

Before Servicing

Disconnect power before proceeding.

Do not tighten past 10 in-lbs torque or the injector tube adapter could be damaged.

Removing the Injector Tube Adapter

The injector tube adapter connects the ozone gas line to the injector manifold.

1. Remove if worn or dirty.
2. Loosen or remove the tubing clamp. Use pliers if necessary to twist and unlock the clamp.
3. Pull the tubing from injector tube adapter and unthread the adapter from the injector.

Replacing the Injector Tube Adapter

1. Apply Teflon® based thread sealant
2. Install new connector
3. Thread the adapter onto the injector
4. Push the tubing into injector tube adapter
5. Reapply the tubing clamp. Use pliers if necessary to twist and lock the clamp. Do NOT tighten over 10 in*lb.