Pre-Installation Information

IMPORTANT WARNINGS

• Do not store or use gasoline or flammable vapors and liquids in vicinity of this appliance.
• Do not install this appliance near any combustibles. A Liquid Propane cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
•  For outdoor use only. Product is not intended to be a starter for wood or any other combustibles. 
• Installation must be performed by a licensed professional. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Installer must follow all local codes as well as National Fuel Gas Code, ANSI Z223.1.
• If you smell gas, shut off the gas to the appliance and extinguish any open flame. If the odor lingers keep away from appliance and immediately call gas supplier or fire department. Do not leave any flame unsupervised.
• Carbon Monoxide Hazard: This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can cause serious injury or death. Never use this appliance in an enclosed space such as a camper, tent, car or home.
• HOT! DO NOT TOUCH. SEVERE BURNS MAY RESULT. CLOTHING IGNITION MAY RESULT.
• Glass and other surfaces are hot during operation and cool-down. CAREFULLY SUPERVISE children near this appliance. Alert children and adults to hazards of high temperatures.

IMPORTANT SAFETY INSTRUCTIONS

Adhere to all local codes concerning installation and operation.

• Test for gas leaks prior to use.
• Verify correct gas fuel type. Never use an alternative fuel, including bio-fuel, ethanol, lighter fluid or any other fuel.
• Installation must be performed by licensed gas piping professional
• When pit is not in use for an extended period, turn off gas to prevent unwanted start-up.
• The use of a cover when not in operation is recommended
• Verify gas shut off is located outside of the fire enclosure. The gas shutoff should NOT be used to adjust flame height.
• An approved gas valve or keyed valve shall be installed upstream of the unit and located in an accessible area that is within 5ft from the unit.

Professional Installation

Installation must be performed by a licensed contractor. Installer must follow all local codes as well as National Fuel Gas Code, ANSI Z223.1. We suggest that our products be serviced annually by a professional certified in the US by the National Fireplace Institute (NFI) as NFI Gas Specialists or in Canada by WETT (Wood Energy Technical Training). Installer must follow all instructions carefully to ensure proper performance and safety.