Pre-Installation Information

IMPORTANT WARNINGS

This waterfall must be installed by a licensed or certified electrician or a qualified pool professional in accordance with the National Electric Code (NEC) or Canadian Electric Code (CEC), CSA C22.1.

All applicable local installation codes and ordinances must also be adhered to.

Improper installation will create an electrical hazard which could result in death or serious injury to pool users, installers, or others due to electric shock.

Always disconnect power to the LED lights before installation.

CMP Brilliant Wonders LED Waterfall 2 is a low voltage light and should never be electrically connected to a power source other than an approved pool “Safety Rated,” UL listed, outdoor rated, 12V transformer or power supply: Brilliant Wonders Color Wheel Control (25650-130300) requires a 12V DC power supply; Brilliant Wonders Smart Sync Adapter (25677-900-000) requires a 12V AC transformer.

Failure to comply will either damage or destroy the light and will void the warranty.

Performance Info

It is recommended to keep the unit in the packaging until the site is prepared for installation.

The units use 1.25 gallons of water per inch of waterfall per minute. Size your water pump accordingly.

Reference GPM when choosing the correct pumps to use.

Protecting During Installation

Each Brilliant Wonders LED Waterfall 2 is shipped with a debris guard for the water outlet and for the water inlet.

These prevent debris from entering and damaging the waterfall unit during installation.

Debris guards should not be removed until the waterfall is ready to run.

Do not leave the waterfall in direct sunlight. This can cause permanent damage and warping to the waterfall unit.

ALWAYS USE A FILTER

Use only water that has been properly filtered by an in-line cartridge filter.

Failure to properly filter water may result in a clogged waterfall and a voided warranty.