LED LIGHT REMOVAL
POWER CABLE WARNING
CAUTION: When removing the LED Light Module, make sure to not let the power cable fall back down into the conduit. Use tape or a paper clip around the power cord to prevent the cable from falling prior to disconnecting.
HOW TO REMOVE THE LIGHT MODULE
REMOVING THE LIGHT
⚠️ Be sure not to damage or misplace the sealing L-Gasket that is underneath the large lens.
To remove the LED Light Module, insert the four snaps on the Installation Tool into the four snap receptors on the small LED lens.
Secure the wire inside the main body and use tape to prevent the cord from retracting back into the conduit.
UNSEAL THE LIGHT MODULE
UNSEATING THE LIGHT
Using a 3/8″ socket extender inserted into the square hole on the top of the Installation Tool, rotate counterclockwise until you feel a click. Keep rotating until the Light Module unseals itself from the conduit.
Now, pull the Installation Tool upwards and remove the LED Light Module.
Congratulations!
You have completed this chapter. To go to the next chapter, click next. To go back to the Chapter Table of Contents, click done.